AGA M24AR Guia de Resolução de Problemas descarregar pdf (Página 21)

⁄8"

(28.4mm)

Typical

⁄4" (6.4mm) thick battens-

⁄4" (6.4mm) Plywood / Panel

⁄16" (4.8mm)

thick back up-

⁄8" (4.8mm)

thick back up-

⁄4" (6.4mm) Plywood / Panel

⁄16" (4.8mm) thick battens-

⁄16"

(61.8cm)

⁄16" (1.6mm) rout

⁄16"

(55.6mm)

⁄2" (12.7mm) Plywood / panel

⁄16"

(7.9mm)

Metal side panel

24"

(61cm)

typical installation

opening

Holes in

roller base-

#8 screws-

Cap-

Figure 27

Figure 28

Instructions for Fastening Side Panels to Re-

frigerator

1. Side panels should be 24 inches deep (or 24

⁄16 inches

deep when tucked into the front trim).

2. Panel height to match installation height.

3. Install the side panels per drawings on the right.

To avoid damage to panels or ooring, raise panels slightly,

to clear oor when installing.

Drill three (3) holes equal distance apart in vertical section

of aluminum frame and install pan head screws as shown.

Anchor side panel with screw as shown. Be sure screw

used goes no more than

⁄2 inch deep into product. Do NOT

overtighten.

NOTE

Kick Plate Installation

Use two (2) #8 sheet metal screws (supplied) to facilitate

holding your kick plate in place. Mount screws in holes in

roller base. Cover screw heads with caps supplied. (See

Figure 28).

INSTALLING SIDE PANELS AND KICK PLATE

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Comentários a estes Manuais

Sem comentários

AGA M24AR Guia de Resolução de Problemas Página 21

Comentários a estes Manuais

Manuais e produtos relacionados com não AGA M24AR